What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP Trap Receiver Sensor shows GenTrap 4 - authenticationFailure

Votes:

0

Hello,

I added the SNMP trap sensor to a device and I tried different filters ('any', source ip + community, only community, etc) but I always get same response = GenTrap 4 - authenticationFailure, even if I set the "community" filter with same word in both sides.

What Im doing wrong?

Best Regards

prtg snmp traps

Created on May 22, 2023 10:37:12 AM



1 Reply

Votes:

0

Hey,
Could you please open a ticket for our support department so that they can take a closer look into the issue. Please click here.

Created on May 24, 2023 8:56:02 AM by Marijan Horsky [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.