New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

300.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


SNMP HP ProLiant System Health

Votes:

0

Your Vote:

Up

Down

Hi, trying to get the "SNMP HP ProLiant System Health" sensor to work but all I get is "No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003)".

  • Servers running Windows Server 2012 R2
  • Firewalls disabled
  • Insight Management Agents and Insight Management WBEM Providers installed
  • Tried with iLo but same error
  • Hp System management hompage working as expected

Do I need to configure anything manually on the server/hp software to get this to work?

hp proliant snmp

Created on Jan 24, 2017 2:38:30 AM by  horizonict (0) 1



3 Replies

Votes:

0

Your Vote:

Up

Down

Hello horizonict,

Thank you very much for your knowledge base post.

The forwarded error message (SNMP error # -2003) usually indicates issues with your current SNMP configuration.

Please check if the SNMP Settings (Version, Community String, port, eventual authentication, etc.) are correct. Then please also check if PRTG (or the PC on which PRTG is installed) is allowed to send SNMP Requests to the device in case.
Please check this article for further information and problem solving approaches: My SNMP sensors don’t work. What can I do?

You can also use our SNMP Tester to test the SNMP-Functionality on the target device.

Best,
Sebastian

Created on Jan 24, 2017 8:07:17 AM by  Sebastian Kniege [Paessler Support]



Votes:

0

Your Vote:

Up

Down

All sorted, had to set the SNMP Community String in the SNMP windows service details. Also only seems to work with PRTG node set to the iLo, not the server. Cheers.

Created on Jan 24, 2017 7:40:28 PM by  horizonict (0) 1



Votes:

0

Your Vote:

Up

Down

Hello horizonict,

Thank you for your reply. Just to avoid misunderstandings please let me allow to ask if you need further assistance on this case.

Best,
Sebastian

Created on Jan 25, 2017 8:18:51 AM by  Sebastian Kniege [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.