What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Default Scanning Intervals? and will change frequency once down?

Votes:

0

Hello,

Firstly I would like to know ss it the default scanning intervals of each sensor is 30s? and where I can verify?

and after read this KB https://kb.paessler.com/en/topic/44643-can-i-change-scanning-interval

Some further question.

1. Does it allow to modify each sensor scanning intervals?

2. When detected sensor down. Does the scanning intervals will speed up or just keep same is default setting?

Thanks!

prtg scanning-interval time

Created on Feb 24, 2017 10:21:33 AM



1 Reply

Votes:

0

Hello,

Thank you for your KB-Post. You can set the interval for most in their settings. And PRTG will keep the same interval if a sensor goes down.

best regards.

Created on Feb 24, 2017 12:03:10 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.