Hi, I need to move some devices and its sensors from one PRTG instllation to another one without loosing what I have in the destination PRTG installation. I do not want to migrate one complete installation to substitute another one, what I need to do is move some devices painstakingly created in PRTG installation 1 to PRTG instllation 2 in another server and keep what I have in istallation 2 as is. Any and all help will be appreciated.
Hi, how can I move some devices and its sensors from one PRTG instllation to another one without loo
Votes:
0
3 Replies
Votes:
0
Dear Jose,
Thank you very much for your knowledge base post.
Kindly note that it is not possible to migrate just certain devices or any part of the configuration between two PRTG installations. The only approach is to proceed a full migration and delete the sensors and devices which are not needed afterwards.
Kind regards,
Sebastian
Created on Feb 28, 2017 9:50:17 AM by
Votes:
0
Dear Jose,
Indeed, you could change the corresponding Core Server of a Remote Probe but this will neither affect nor migrate devices and sensors.
All devices, sensors, historic data and the configuration from the Local Probe as well as all Remote Probes is saved on the PRTG Core Server. If you change the Core Server address, the Remote Probe is pointing to, a new and empty Remote Probe will have to be approved on the new PRTG Core Server.
You will have to either fully migrate PRTG or create the devices and sensors again.
Kind regards,
Sebastian
Created on Mar 1, 2017 6:44:14 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment