Wanting to know is there any way to download and install new sensors - like Visio stencils for more current and specific pieces of equipment such as Nexus 9K switches? Also want to know how can I tell easily which sensors are snmp v3 capable? We are looking to start using SNMP v3, but wondering if there enough sensors to configure on the hardware side.
snmp ver 3 - new sensors for Cisco Nexus
Votes:
0
1 Reply
Votes:
0
Hello there, thank you for your KB-Post.
You might want to check out the following:
Otherwise, consider using Custom Sensors or an MIB File to deploy custom sensors:
- Can't find a sensor for my device in PRTG but I believe it supports SNMP. How to proceed?
- What can I monitor with the SNMP Custom Table Sensor?
As, for SNMP V3, except for the SNMP Trap Receiver, all other SNMP Sensors in PRTG are SNMP V3 compatible.
Best Regards,
Luciano Lingnau [Paessler Support]
Created on Apr 6, 2017 1:50:43 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment