Somehow I can restart a device through the PRTG
Example: A Mikrotik device stops responding and then I reboot it via the PRTG via SNMP.
SNMP - reboot devices
Votes:
0
1 Reply
Votes:
0
Hey Leonardo,
Thank you for your KB-posting.
Actually, this is not possible with our native sensors as PRTG uses SNMP get and walk only (but no set which is required to change anything on the device or to trigger any action, like a reboot).
However, please refer to this article which might point you in the right direction.
Kind regards,
Sven
Created on Jul 7, 2017 6:18:01 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment