What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags

View all Tags

Problem with sensor snmp memory (error SNMP # -2003)



I need install a sensor in PC (windows), i need monitor memory and have this error

memory pc snmp

Created on Dec 6, 2018 6:42:36 PM

1 Reply



Hey ecaldas,

The error message shown (SNMP error # -2003) indicates a timeout and/or that PRTG is not able to receive the requested information via SNMP.

Please verify that SNMP is properly configured on the monitored device and make sure to enter the SNMP credentials in the device settings properly.

Also, please check and confirm if the SNMP service is properly installed on your target device.

Also, please see our SNMP troubleshooting guide.

Best regards,
Sven Roggenhofer [Paessler Technical Support]

Created on Dec 7, 2018 6:05:02 AM by  Sven Roggenhofer [Paessler Technical Support]

Last change on Dec 7, 2018 6:06:37 AM by  Sven Roggenhofer [Paessler Technical Support]

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.