We just noticed that there is no notification if the CPU load is at 100%, it still is GREEN. We want to make sure that if the CPU utilization is above 80% it turns yellow for warning and above 90% it is Red for down. How do we do this for all servers so it inherits throughout all our sensors?
setup CPU load notifications for all servers
Votes:
0
1 Reply
Votes:
0
You're looking for library based notifications :) That'll allow you to add notifications to multiple sensors at once, without touching every single sensor. See also the Paessler website: How to set up notifications via the PRTG web interface.
PRTG Scheduler |
PRTGapi |
Feature Requests |
WMI Issues |
SNMP Issues
Kind regards,
Stephan Linke, Tech Support Team
Created on Jan 28, 2019 8:15:06 PM by
Last change on Jul 26, 2021 10:46:35 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment