New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Stop running Reports

Votes:

0

Your Vote:

Up

Down

Hello,

is it possible to stop a report that has already been started? because too many sensors were selected due to an incorrect configuration.

process question reports

Created on Oct 18, 2021 8:44:37 AM by Michel Power (1) ●2



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello Michel,

Thank you for your message.

Regarding the generation of the report, I'm afraid that it is not possible to stop them at the moment. In such case, you can wait until the generation reaches the defined timeout value (default 1 hour) or restart the Core server in PRTG Administration Tool > Service Start/Stop.

If needed, you can change the timeout value by following the steps provided in this KB article: https://kb.paessler.com/en/topic/11233-how-can-i-change-the-default-timeout-for-report-generation-in-prtg. However, note that reducing the timeout might prevent the generation of existing reports.

Regards.

Created on Oct 19, 2021 6:22:19 AM by Florian Lesage [Paessler Support]

Last change on Oct 19, 2021 6:23:32 AM by Florian Lesage [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.